Application Instructions

Iron-On Instructions for Diamante/Rhinestone Transfers.

PLEASE CHECK THE TRANSFERS, AS SOME RHINESTONES MAY HAVE
MOVED DURING TRANSPORTATION. IF SO PLEASE RE-PLACE USING
TWEEZERS.

- Prepare on a hard flat surface. (Ironing Board)

- Peel off the White backing paper.

- Place the sticky side down on the fabric.

(Where you would like the Transfer to go)

- If you need to re-adjust, Pick it up completely and place down again.

(Do NOT try to slide it across )

- Place a THIN cotton cloth over the transfer to protect your garment.

(Example: THIN tea towel or OLD EMPTY Pillow Case etc...)

- Set your Iron to the heat Setting for Cotton - Max

 (DO NOT USE STEAM)

- Place the iron down for around 30-35 seconds each time on each  area of the transfer.

 Make sure you have covered each area.

- Then to ensure that all the rhinestones have stuck down well.

Carefully turn your garment inside out and apply heat for 5 seconds again to each section.

- Allow to cool for around 2 minutes, until it feels cold.

- Then peel of the transfer paper.



(If there are any loose stones, repeat instructions)